Feed chart
additivesbases
| Stage | vegetative Growth | reproductive Growth | flush | |||||||||
| week | 1 | 2 | 3 | 4 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| EC | 1.0 | 1.3 | 1.4 | 1.4 | 1.7 | 1.7 | 2.2 | 2.4 | 2.1 | 1.8 | 1.2 | - |
| ppm(tds/500) | 500 | 650 | 700 | 700 | 850 | 850 | 1100 | 1200 | 1050 | 900 | 600 | - |
| Grow a | 4 | 6 | 6 | 6 | - | - | - | - | - | - | - | - |
| Grow b | 4 | 6 | 6 | 6 | - | - | - | - | - | - | - | - |
| Bloom a | - | - | - | - | 10 | 10 | 10 | 12 | 12 | 10 | 8 | - |
| Bloom b | - | - | - | - | 10 | 10 | 10 | 12 | 12 | 10 | 8 | - |
| E-PLUS* | 2 | 2 | 3 | 3 | 2 | 2 | - | - | - | - | - | - |
| bulk | - | - | - | - | 2 | 2 | 6 | 6 | 3 | 3 | - | - |
Feeding Tips
-ml per 1 US gallon (unless otherwise noted)-These rates are based on distilled water. Water quality will vary and may increase the PPM/EC.
-This chart is a basic guideline. Use recirculating or runoff PPM to adjust as needed.
-If using a recirculating system, amended media, or feeding multiple times a day, reduce initial feed rates by 25%.
-Measure the PPM of runoff weekly; runoff should be within +/- 20% of initial feeding.
-For longer vegetative cycles, continue week 4 feeding.
-For longer reproductive cycles, continue week 4 feeding.
*1 mL/gal of E-PLUS may be used throughout flowering if additional nitrogen is needed.
pH Tips
-These products are most effective when the pH is unadjusted.-If pH falls below 3.0, adjust with potassium hydroxide; do not use potassium carbonate or potassium silicate (pH of 3.0 or lowermay result in nutrient deficiency).
-If pH rises above 6.0, adjust with phosphoric, nitric or sulfuric acid.
-Using an air stone in a standing reservoir is not recommended with ourproducts, as they contribute to rapid rise in solution pH. Gentle agitation, such as with a recirculating pump, can be used if agitation is required.
3 time a week
5 time a week
200 Gallons
additivesbases
| Stage | vegetative Growth | reproductive Growth | flush | |||||||||
| week | 1 | 2 | 3 | 4 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| EC | 1.0 | 1.3 | 1.4 | 1.4 | 1.7 | 1.7 | 2.2 | 2.4 | 2.1 | 1.8 | 1.2 | - |
| ppm(tds/500) | 500 | 650 | 700 | 700 | 850 | 850 | 1100 | 1200 | 1050 | 900 | 600 | - |
| Grow a | 4 | 6 | 6 | 6 | - | - | - | - | - | - | - | - |
| Grow b | 4 | 6 | 6 | 6 | - | - | - | - | - | - | - | - |
| Bloom a | - | - | - | - | 10 | 10 | 10 | 12 | 12 | 10 | 8 | - |
| Bloom b | - | - | - | - | 10 | 10 | 10 | 12 | 12 | 10 | 8 | - |
| E-PLUS* | 2 | 2 | 3 | 3 | 2 | 2 | - | - | - | - | - | - |
| bulk | - | - | - | - | 2 | 2 | 6 | 6 | 3 | 3 | - | - |
Figures above correspond to total gallons of each product required per cycle.
Note: the logic shows the total gallons of each product used per week - nothing else.
pH Tips
-If pH falls below 3.0, adjust with potassium hydroxide; do not use These products are most effective when the pH is unadjusted.-potassium carbonate or potassium silicate (pH of 3.0 or lowermay result in nutrient deficiency).
-If pH rises above 6.0, adjust with phosphoric, nitric or sulfuric acid.
-Using an air stone in a standing reservoir is not recommended with ourproducts, as they contribute to rapid rise in solution pH. Gentle agitation, such as with a recirculating pump, can be used if agitation is required.